Uspeo da nabavim jedino FASEC 33, do sada sto sam ugrađivao je jednostavno bio omodul , koji je povezan, bez ikakvih podesavanja, i to tako radi.
Kod ovog modela, ima 3 trimera za podesavanje.
Gledjauci uputstvo, nije mi bas najjasnije kako ga podesiti.Evo i slike koji je model u pitanju.
a u uputstvu pise sledeće :
The operation logic of FASEC 33 is based on
the concept that as temperature increases
an increase in the number of turns of the
applied load (condensation) follows.
The regulation Set is set through the central
potentiometer “0% speed” (scale 0…60 °C).
The temperature differential, which determines
the temperature at which the load
turns at the maximum speed when summed
to the Set value, is set through the “100%
speed” potentiometer (scale 3…31 °C).
The “min speed” potentiometer allows to
set a minimum speed below which the
motor will never operate.
It is used in case of high inertia loads that
FASEC 33 cannot control when the output
controlling voltage is very low. Example of
application: let’s assume the starting temperature
is set to 30 °C (0% speed) with a
differential of 10 °C (100% speed).
When the temperature reaches 30 °C the
fans begin to turn at a speed which is slightly
higher than the minimum set; when the
temperature reaches 40 °C (30+10) the fans
operate at maximum speed.
Konkretno u ovom slučaju ( ukoliko sam dobro shvatio) kada je temperatura kondenzacije 30 stepeni ventilator počinje da se okreće min brzinom, kako ta temperatura raste do 40 stepeni kondenzacije, brzina ventilatora ce se povecavati do svog maksimuma koji ce biti na toj temperaturi.
POšto se ova klima koristi za hlađenje i leti i zimi , zanima me koji temperaturni opseg podesiti na regulatoru tako da bi to radilo kako treba . Po mom nekom mišljenju to bi trebalo da bude baj taj primer od 30 stepeni + 10 stepeni.
U principu to se treba podesiti samo za letnje uslove,jer ce vecinu vremena u zimskom periodu ventilator mirovati zbog niske vanjske temperature.
